User:LomeboDokuva
Jeeps are fashioned with off-roading in mind; these folks were designed to endure the punishing treatment presented by off-road trails. Over these outings it can be not uncommon for the Jeep to take a beating, with many of this beating being towards the underside of your respective Jeep. It is typical to the gas tanks on Jeeps to get damaged because of debris and large rocks one encounters while off-roading. To help reduce the chance with this happening in your vehicle it really is suggested which you use a skid plate. A skid plate serves like a shield for the vehicle's gas tank and takes all of the punishment that your gas tank was exposed to. Some Jeep models already have skid plates installed, if yours is but one with the models that doesn't we have been going to walk you from the steps of installing a skid plate on your own Jeep.
The very first thing that needs to become done just before installation is to open the hood of one's vehicle and eliminate the fuel pump relay in the junction box located about the passenger side from the Jeep. After that has been done you ought to start your engine and let it run provided that it will this will depressurize the high-pressure lines that come from the fuel pump and can make working near to your gas tank safer. After the Jeep has stopped running you may have to eliminate the negative battery terminal making certain Junction box does not come into connection with any metal.
Next you may should remove the cap located on the fuel filter along using the four torque screws that contain the fuel filter cap in your vehicle. This may be done utilizing a T25 socket wrench to take away the torque screws. After you've completed that step you will now must remove some in the bolts which are employed to hold the stock tank and skid on the underside of your respective vehicle. Do not remove all with the bolts, you will must leave two bolts in the rear the other inside the front in order that the tank and skid plate, if you currently have one installed, will not likely drop together with you while you eventually be working. You need to now place a floor jack underneath the tank and improve the jack to keep the gas tank; this will allow you to take away the bolts you left intact.
Once all in the Waterproof equipment cases are already removed and the tank is secured by the jack you may now need to disconnect the fuel lines, evaporator lines and many types of in the other connections that run towards the gas tank. It is achievable to disconnect the high-pressure fuel line through the top with the fuel tank by detaching the blue clip holding it in place. Next you must remove the red safety clip using a small screwdriver and eliminate the electrical line. Using a screwdriver you will also have to eliminate the emissions lines, and remove the lines from your clips that hold it on the gas tank. These clips might be found for the top side of the tank.
After all in the lines are actually removed through the gas tank you ought to now eliminate the stock strap which is accustomed to secure the tank towards the vehicle. Unbolt the straps and set the vehicle's gas tank into the new skid plate you occur to be installing and push it into place and put the straps back in the tank and re-bolt the straps on the tank. Before tightening the bolts completely you should ensure that this gas tank and skid plate are centered. Now while using jack you will have to slide the tank and skid plate beneath the Jeep and reconnect all from the lines you disconnected earlier. Be sure your connections are tight as a way to prevent leaks. After you've got reconnected all from the lines in your gas tank you should now use the jack to raise the tank and skid to the bottom of one's vehicle in places you will then re-bolt Electrical enclosures to the underside of your respective Jeep.
Now your gas tank and skid plate have re-bolted for your vehicle it can be done to now reinstall the fuel filter and replace the torque screws which you removed earlier. After you have secured it it is achievable to now place the fuel pump relay back in to the junction box and reattach the negative battery cable to the battery. After completing these steps you may now possess a skid plate that may protect your vehicle's gas tank from damage while off-roading.
